+90 444 98 93

TR      EN 

CORPORATE

Test Center




TESTBENCH


In our Test Station, 170 kW, Servo Electric Motor controlled testbench, 0-3000 rpm range, open and closed circuitsinglepumps, multiplepumps and hydraulic motors can be tested. At 600lt/min dynamic test workshop; work and efficiency tests are performed. Test results are presented to the customer in table and graphically.

In hose manufacturing center, hose selection is made according to the technical requirements of the customer. The technical drawings from the customer are examined and work orders of the hoses to be manufactured are prepared by experienced technical engineers. First, the hose is cut to the specified dimensions. The cut-off hose is cleaned with compressed air. Then the hose is skived at the specified dimension in the work order. The fittings are inserted with equal size and desired orientation in fitting insert machine. The next step is to the hose press. Measure and check the thread and dimensions before the höse is pressed. After that the höse is pressed according to the standards and dimensions specified by the hose and fittings manufacturer. Dimensions are checked after pressing again. Afterwards, the static test is performed in 4-channel test unit (up to 1000 bar) at the pressure and time specified in the work order for the Proof Test.

 

At the hose cleaning unit, hose washing is carried out with special solvents that will not damage the hoses and fittings, The operator clean the remaining solvent and oil with the compressed air. Cleaned hoses suspended for the perfect dry. The labels of hoses are prepared. Then, in the final control section, the lengths, orientations, pressing diameters, labeling information of the finished hoses are checked and the plugs of each end are attached and each hose is packed separately and then put into the specially prepared boxes. Hose test reports can be presented as soft or hardcopy to our customers in batches as well as with each hose.


Hose and Pipe Manufacturing Standards

 

ISO / EN STANDARDS

•EN 853 / Rubber hoses and hose assemblies – wire braid reinforced hydraulic type –specification(hydraulic applications)

•EN 854 / Rubber hoses and hose assemblies -textile reinforced hydraulic type –specification(hydraulic applications)

•en 856 / rubber hoses and hose assemblies -rubber-covered spiral wire reinforced hydraulic type –specification(hydraulic applications)

•en 857 / rubber hoses and hose assemblies -wire braid reinforced compact type –specification(hydraulic applications)

 

SAE J517 STANDARDS

•SAE100R1 One wire braid

•SAE100R2 Two wire braids

•SAE100R3 Two textile braids

•SAE100R4 Textile plies or braids with spiral body wire (suction hose)

•SAE100R5 Two textile braids separated by one wire braid

•SAE100R9/R10 Four spiral wire plies

•SAE100R13 Multiple spiral plies of heavy wire

•SAE100R15 Six spiral wire plies

•SAE100R17 Constant pressure rubber hose 21,0 MPa

•SAE100R18 Constant pressure thermoplastic hose 21.0 Mpa



Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center
Hose Manufacturing Center

CUSTOMER SERVICE

+90 444 98 93 - +90 533 427 70 77

Melih Gökçek Bulvarı No:8  ANKARA
P. 444 9893 • F. 0(312) 395 23 27

info@hidrokontrol.com.tr

Subscribe to Newsletter

HİDROKONTROL © 2018 |  All Rights Reserved